motorcycle vinyl wrap Two pieces of vinyl wrap film are used to wrap the hatchback trunk.

motorcycle vinyl wrap

Vinyl wrap film is easy to wrap many hatchback trunks. motorcycle vinyl wrap Some trunks, however, are more difficult because of their thick rear section and steep angles. Wrapping it in one single piece of vinyl wrap film will cause the material to stretch. motorcycle vinyl wrap The film will rebound over time. The film's durability is therefore very low. Wrap it in two pieces vinyl wrap film and then make a overlap. Here's how it works: To form the trunk's rear section, apply the film and pull it evenly using triangle shapes. motorcycle vinyl wrap Make a hinge at the center of the trunk and then wrap the film around the trunk. You want it to be flat and free from wrinkles.

Once the film has been properly positioned, you can run your finger between the two trunk sections to hold the material in place. Use a sharpening blade to trim along this edge. To avoid cutting the car, make sure that your blade is parallel to the trunk's front section. motorcycle vinyl wrap As your other hands cut, pull the vinyl wrap film in an even tension. This will help you to achieve straight and clean cuts. After you have made the cut, remove any excess film and seal it with your finger. motorcycle vinyl wrap Next, trim and handle the rear edge in the same manner. After you are done cutting, use your squeegee and read the material to flatten out any wrinkles. After you are done cutting, seal the edges. The trunk's rear section should now be wrapped. Now it's time to tackle the front. motorcycle vinyl wrap Keep the trunk open by propping it with a suitable tool. Place another vinyl wrap film in this area and move it around until it is fully set. You can sharpen your blade once more and continue cutting in the same manner as the rear section.www.vinylcarwrapshop.com motorcycle vinyl wrap But this time, your blade should be parallel to the back. After you are done, remove any excess film and seal it. This will create a seamless overlap. You can also wrap in two pieces to reduce stress. motorcycle vinyl wrap Because there isn't much tension you can handle the two sections as if they were a flat surface. It is a sign of good fortune to invest in quality and durability. For more wrap tips, visit teckwrap.com hatchback Overlap Overlay Recessed area steep angle trunk